LED 2835 ribbons
It is no secret that the "life" of LED strips is significantly reduced, primarily due to overheating. Most often, bright ribbons can not do without heat dissipation, the best way to provide it LED profiles, we, by the way, their range is very wide. When creating LED 2835 tapes, the engineers took into account this drawback associated with heating the board and the crystals on it. They found an original solution to this problem, the technology they have developed, called encapsulation. With its help it was able to cope with such a frequent phenomenon as overloading of LEDs due to high frequency current. The fact that the new technology makes it possible to place in one body crystals, not only of equal power, but different. If you decide to decorate the interior of your car, its hood, the facade of the house, or something inside, such as a niche, shelf, handrails or steps, alcove, furniture, closets, floor, mirror, window panes, shower stall or bathroom, loggia, or even billboards, or cold stores, then an excellent solution for this is to buy LED 2835 strip. Even compared to their "brothers" SMD 2835 has lower power consumption, with 120 LEDs per meter consumed only 28.8 watts. Do not forget that this is at a light emitting power of 20 lumens per diode. Even with intensive daily use, the SMD 2835 can last up to 100,000 hours. Please note that by choosing premium you get extra power as well as a longer warranty period for the led tapes. All you need for connection (power supply, controller and dimmer) you can buy from us in the appropriate sections. But before you buy 2835 LED strips, you need to be determined with a class of protection, if you need to protect the tape from moisture or direct ingress of water, then do not take the usual IP20 or IP33, in the bathroom and on the street you need or IP65, where the crystals are covered with silicone on one side, or IP67, where the tape is inside a rubber tube. LED 2835 strip has a maximum length of 5 meters, the minimum there is no limit, except for the advice not to cut a piece of less than 5 inches, equal to three LEDs, otherwise you simply will not be able to connect it. How you want to place the flexible circuit board is up to you, nothing limits your imagination, neither any surface topography (the tape will repeat it), nor the complexity of installation (the adhesive back side is very easy to attach).
Автор: LEDProm