Dimmer control SUNRICHER for 8 zones IP20 (SR-2833K8)

After you have connected all the receivers according to the picture, you need to do the following:

1. Make sure that the circuit is assembled correctly, the polarity of the connection is observed everywhere, and the wires are not shorted anywhere. 2. Power on the controller or dimmer. 3. Pair the remote: Short press the pair button on the controller or dimmer.On the remote control, press the ON or OFF button of one of the five zones to which you want to bind the dimmer.The LED strip connected to the dimmer will flash to indicate successful binding. 4. Check tape control from the remote.A short press of button 1...8 turns on or off the light in the corresponding zone. Pressing button 1...8 increases or decreases the brightness in the corresponding zone.Each subsequent press and hold of button 1...8 changes the direction of the brightness adjustment.Pressing the ON button turns on the light in all zones.Pressing the OFF button turns off the light in all zones. 5. An unlimited number of controllers or dimmers can be assigned to each console zone. Repeat the pairing operation for each device. All linked dimmers of one zone will be controlled simultaneously. Dimmers must be within range of the remote control. 6. Up to 8 remote controls or control panels can be linked to one controller or dimmer (see the instructions for the equipment used). 7. To clear the controller's memory and unpair all remotes and control panels, press and hold the Pair button on the controller for more than 5 seconds.